The device allows producing bags with welded edges on a vertical or horizontal packaging machine.

Technical parameters        
Machine type SH440 SH550 SH600 SH730
Foil speed (m/min.) to 14 to 14 to 14 to 14
Foil width (mm) to 440 to 550 to 600 to 730
Power supply 230 V/50 Hz
230 V/50 Hz
230 V/50 Hz
230 V/50 Hz
Power (W) 1200 1200 1200 1200
Air consumption at 0,6 MPa (l / cycle) 60 60 60 60
Noise (dB) do 75 do 75 do 75 do 75

Types of welded edges
overlapping edges
welded edges

Bag types
bag with welded edges and folded bottom
bag with welded edges, folded bottom and folded upper weld with a sticker
flat bag with welded edges and in-folded sides

Description
when used on machines ASTRO with a control system B&R, the device uses the packaging machine control unit
if the device is used on a machine from another manufacturer, it uses its own control unit
Festo pneumatic drive
electronic control system resistant against short circuit, polarity inversion, overload
electric coverage IP 44
all function setup from the control panel
all components are protected with a surface treatment corresponding to health regulations
all components are protected with a surface treatment corresponding to health regulations
when using one-side weldable foil, the edges are overlapping
when using two- side weldable foil, the edges can be welded
suitable for PP foil and other PP-based laminates
the device has industrial patent

Application
the device can be used on packaging machines from other manufacturers. Installation using a special bracket according to the type of the packaging machine
on machines ASTRO with a control system B&R the device uses the packaging machine control panel

Advantages
possible to install on machines from other manufacturers
can be used with new or older packaging machines
can be used for all bag sizes and types
does not limit output of the packaging machine
easy and reliable actuation
easy installation